loaderimg
What
image
  • imageBuilding
  • imageContractors
  • imageExterior
  • imageInterior
  • imageOutdoors
  • imageSuppliers
Where
image
image

Country: Africa

image
15 November

A lintel is a structural member that spans an opening, such as a door or window, and transfers loads to supports on either side. It allows masonry or other construction above the opening to remain supported. The correct lintel depends on the span, loads, support conditions and construction system. How a lintel carries loads The […]

Read More
image
15 November

Brick walls need movement joints to accommodate changes in dimensions caused by temperature, moisture and other movements without creating excessive restraint stresses. A properly designed joint allows adjacent masonry sections to move relative to one another. It can reduce the risk of uncontrolled cracking, but cannot compensate for inadequate foundations or structural design. Why masonry […]

Read More
image
15 November

A damp-proof course (DPC) is a barrier installed in a wall to limit moisture movement through masonry, particularly rising damp from the ground. It forms part of a wider moisture-management system that includes drainage, floor membranes, flashings and appropriate wall detailing. How rising damp occurs Porous masonry and mortar can draw water through small connected […]

Read More
image
15 November

A raft foundation is a designed foundation slab that supports multiple walls or columns and distributes building loads over a substantial area of ground. It may incorporate beams, ribs or thickened zones. A raft can help manage differential settlement in suitable circumstances, but it is not a universal solution for weak or moving soil. How […]

Read More
image
15 November

A strip foundation is a continuous footing that spreads the load from a wall along its length into the supporting ground. It is commonly used beneath load-bearing masonry where the soil and building design permit. Its width, thickness, depth and reinforcement must be determined for the actual project. How a strip footing works A wall […]

Read More
image
15 November

House foundation depth is determined by ground conditions, building loads, settlement risk and the approved foundation design. There is no single safe excavation depth for every South African house. The footing must transfer loads to suitable ground while limiting movement that could damage the structure. How soil affects foundation depth Topsoil, organic material and uncontrolled […]

Read More
image
15 November

Building cost per square metre is the total cost of a defined construction scope divided by the corresponding floor area in square metres. A R1,500,000 building contract for 150 m² produces an indicative rate of R10,000/m². This is an arithmetic example, not a current South African market rate. Step 1: Establish the floor area Use […]

Read More
image
15 November

Cement is a powdered binder; concrete is a composite material made by mixing cementitious binder, water, sand and coarse aggregate. Cement reacts with water to form a hardened paste that binds the aggregate. You buy cement to make a mix, but you use concrete to construct elements such as foundations and slabs. What is cement? […]

Read More
image
15 November

A single-leaf wall using bricks measuring 222 × 106 × 73 mm and nominal 10 mm mortar joints requires approximately 52 bricks per square metre of wall face before wastage. This is a calculation for that particular brick module, not a universal quantity for all bricks. Larger units, different bonds and joint dimensions change the […]

Read More
image
14 November

Explore construction apprenticeships in South Africa, including trade choices, entry requirements, accredited training and trade tests.

Read More